Tuesday, February 07, 2012
Discussion Forum Register   Login
     
 
Welcome to the A400 Group discussion forum.  You can browse directly in any of the forums below, or login or register to start posting your own messages.
 rtw
The A-400 Group Forum
 
You are not authorized to post a reply.
Author
  Messages Sort:
Jim Rydelius
Posts:27
Posted:01/20/2009 11:09 PM
Near the bottom of the fender wells on my A400 are (or were before I cut out the very rusted part of this area)three holes approximately 3/8 inch in diameter. They were a half inch or so above the fold in the sheet metal where it goes under the wood sill. I assume these holes were for wood screws but am not sure. Can someone give me details on this? Thanks. Jim Rydelius

bill
Posts:109
Posted:01/26/2009 2:24 PM
yes these are where wood screws go ii if they are as shown in the attached photo.




Jim Rydelius
Posts:27
Posted:01/27/2009 5:06 AM
Thanks so much for confirming my assumption on the purpose of these holes. Jim

You are not authorized to post a reply.


ActiveForums 3.0
 
     
 
     
Terms Of Use   Privacy Statement Copyright 2002-2007 A400 Group