Tuesday, February 07, 2012
Discussion Forum Register   Login
     
 
Welcome to the A400 Group discussion forum.  You can browse directly in any of the forums below, or login or register to start posting your own messages.
 rtw
The A-400 Group Forum
 
Forums > The A-400 Group Forum > General Discussion
Subject: Wiper Motor Rubber
Forums Search
You are not authorized to post a reply.
Author
  Messages Sort:
arlen
Posts:27
Posted:05/02/2008 3:21 AM
A quick question. My car has the correct wiper motor in it, I just took it out of the windshield and the rubber ring that is mounted in the windshield has seen better days. I took a look through Brattons and I dont see anything like it. Is this somthing that I am going to have a hard time finding?

bill
Posts:109
Posted:05/05/2008 7:07 PM
Arlen The wiper is held in place by a nut with a flat washer that compress a flat groment. The washer is .72 OD with A .375 ID and is about .020 thick and the wiper shaft dia is .31. So I made a groment out of some rubber sheet stock. I made it .75 OD by .31 ID. the thickness I am using is .04, which is the sheet stock that I happen to have, but I think anything around .06 would work. I have not been able to find a print for the part. If you need a piece of the sheet stock email me and I will send you a piece.

You are not authorized to post a reply.


ActiveForums 3.0
 
     
 
     
Terms Of Use   Privacy Statement Copyright 2002-2007 A400 Group